.32 Remington reloading

[Quietguns00]

I’m new to the group, I have a 1918 Remington model 14 carbine in .32 rem, searching for a set of rcbs reloading dies and shell holder.

[Mainspring]

I'm not sure that RCBS is still manufacturing dies in .32 Rem, you might contact them direct to confirm. If they are making and selling then you should be able to buy direct, or they might be able to tell you where the last shipment was sent. Online auction sites are a choice on the used market.

[nambujim]

Probably a little late for this post but you see .32 Remington Dies on Ebay from time to time and even on Gunbroker. I'm pretty confident that Redding still makes them.

Use only round nose bullets and both .323 (8MM) and .321 work, my preference is the 8MM. Find an old loading manual for the 70's or 80's (again on Ebay) and use the loads suggested for the .32 Winchester Special......................and always use a factory crimp die, set your dies using an old factory round.

Jim Peterson
Charlotte, NC

[Quietguns00]

Any intel for case length trimming? Not sure if I’ll be able to find a .32 REM case length gauge and holder.

[Lucky Sarge]

The 1959 Speer loading manual shows the "32 Remington rimless" case length at 2.050 hope that helps

[Quietguns00]

I’m aware of the length, but I’ll need a case length gauge and holder to put the brass on my trimmer. That’s where I’m stuck. Because they make caliber specific holders and length gauge that goes into the center of the case while trimming.