Beware of scammers.

I’m aware of the length, but I’ll need a case length gauge and holder to put the brass on my trimmer. That’s where I’m stuck. Because they make caliber specific holders and length gauge that goes into the center of the case while trimming.

Any intel for case length trimming? Not sure if I’ll be able to find a .32 REM case length gauge and holder.

Rickster wrote: Tue Feb 16, 2010 12:43 am The front sight ramp is machined on the barrel, not soldered on. You cant knock it off.

Tang sight screws are 0.140x44tpi. A 6x48 screw is smaller (.130 shaft).

My 141 front sight ramp was soldered on, i cut mine down, heated it and it came off. Resoldered it back on as well.

I’m new to the group, I have a 1918 Remington model 14 carbine in .32 rem, searching for a set of rcbs reloading dies and shell holder.