RESEARCH PROJECT: BELT/RYDER REVOLVERS

[aardq]

Hi Henry,

Here is a drawing of the DA Belt internal parts, done by Karl Moldenhauer in the 1980s, with the nomenclature.

1- Hammer 8- Hand Link
2- Sear Pivot Pin 9- Trigger
3- Sear 10- Cylinder Bolt (single tine)
4- Main Spring stirrup 11- Cylinder Bolt Spring
5- Main Spring Stirrup Pin 12- Trigger Pivot Screw
6- Main Spring 13- Hammer Pivot Screw
7- Hand

[attachment=0]Belt - Karl-Internal Parts - 3.jpg[/attachment]

[aardq]

Hi to All,

Just a reminder that the research is still on-going. Only about 400 serials so far, and that doesn't come close to the 10% usually needed to make some educated assumptions (guesses). A major problem is that in 1870, 4,500 SA Belts were sent to France, so right off the bat, 45% of Belts are basically out of reach of any research.

The monograph does answer some questions, and gives a better idea of the numbers made. It was updated with the French info, and the search for information continues.

Daniel Pozarek

[aardq]

Hello to the Remmy fans,

It's time to remind all that this research project still continues, and we are still looking for info on all Belt Models, the SAs and the DAs, or Riders. So far we have over 300 numbers, and have come to a few conclusions based of the info provided, including a very surprising sale!

The more info we get, the more we learn about these fascinating pistols.

Thank you all for your help and support,
Daniel